Air Engine: Crankshaft and Air Bus

Posted by on Oct 6, 2012 in Videos | 6 comments

Making the Crankshaft and Air Bus for My Inline 4 Air Engine design. This is most likely the final video for the construction of my inline 4 Air Engine. In the end the air bus was a bit difficult to build and hookup, I may rework it. My Air Engines all use my same Piston-Value design. Plans are available from JEPLANS.COM
Video Rating: 5 / 5

Share

6 Comments

  1. Thanks, I have one more video to make of engine just running but, July was pretty busy and I didn’t get a chance to build it’s power delivery system. Hopefully I will have a little more time for projects this month.

  2. This is a great series of videos, Kudos.

  3. thx for the share

  4. Thanks

  5. like your videos!!!!!!!!!!!!!!!!!!!

  6. Well sure, it would really just be 2 of these set 90 degree apart, with a little crankshaft redesign could be done without needed more bearings. I don’t plan on making one at least not for awhile. My next engine efforts will be making tubeless one possibility out of acrylic or polycarbonate and one that is 1/4 the size.